Maestro Invader Distortion Effects Pedal (Pre-Owned)
Image & Video Gallery
Frequently Bought Together
Manufacturer's ID: MOCIDP
The Invader is a high-gain, all-analog modern distortion pedal with an aggressive, dominant sonic character and rich harmonics, generating a wide range of distorted sounds. The 3 -knob control layout offers intuitive control over Gain (distortion amount), Tone, and output Level, with more than enough volume on tap to easily exceed unity gain when d desired. Players can also engage a built -in noise gate with the top panel toggle switch. An internal trim p ot mounted on the circuit board inside the pedal allows adjustments to the level of the noise gate’s Threshold. The true bypass footswitch triggers the LED lights in the bugles in the Maestro logo when it’s on, so you’ll always know when the effect is active.
Condition Report
At guitarguitar, we award our used gear a grade from 1-5 according to its overall condition, with 5 being the best.
This item was appraised as follows:
Grade 4 out of 5 - Item shows some mild and/or minor signs of use such as superficial scuffs and marks. The unit functions as it should and is ready to use immediately.
Accessories Included with this item are as follows: Box and instructions
We take care to photograph any features, wear, tear, or modifications you might want to see before you make the decision to buy.
All of our pre-owned electronics are covered by our 3-month warranty and have been inspected and play-tested before resale.
Specification
- Controls: Gain, Tone, Level; internal Noise Gate Threshold trim pot
- Internal Trim Pot: An internal trim pot on the circuit board allows the user to adjust the level of the Noise Gate’s Threshold. Using a small screwdriver, turn this control up for a higher Threshold level, and down for a lower Threshold level.
- Switches: True Bypass footswitch, Gate On/Gate Off toggle switch
- LED Indicators: Red, yellow, and blue bugles in the Maestro logo illuminate when the pedal is active
- Signal Processing: All-Analog
- Power Requirements: 9V battery or regulated 9-12*VDC power supply (5.5 x 2.1mm plug, wired center -negative) *Running the pedal at 12V provides increased headroom
- Power On Switch: Incorporated into the input jack. Unplug the input when not in use to prevent battery drain. Remove the battery when the pedal is going to be stored for long periods to prevent leakage and damage.
- Input Impedance: 100K ohms
- Output Impedance: 100 ohms
- Switching: True Bypass
- Dimensions (D x W x H): 5.04” x 3.45” x 2.5”, including feet, knobs, jacks, etc
- Weight (Including Battery): 1.1 lb. / 498.95 gm.